Do I have to use a specific pole diameter size?
The instructions tell you how to fit various size poles.

Should I cut the pole to the width of my window or do I need to make it longer?
It depends on your brackets and finials. Determine how much pole you need for the valance and if you need extra room at each end to install the brackets and finials. It’s a good idea to make the valance about 1 1/2” (each side) wider than the window, if you can.

The pattern states that it should not be made less than 32” wide. My window is 30“ wide. What will happen?
Small sizes will cause the top pleats to pull against the long tapered pleat (not allowing it to lay flat). Do a mock up to see if you like the effect.

Where do you determine the “depth” of the valance to be?
At about the middle of the valance, from the top of the valance to the bottom of the valance, not including any trim, not including the pole.

How can I convert the pattern to a board mount instead of a pole mount?
We have recently added those instructions to all the Moreland instruction booklets. You can also get them on our TIP_OF_THE_MONTH_Feb_2005. They are also in the Manual, page 6A-95.

When I add 2 1/4” to the valance for a board mount, should I also do the same with the short jabot?
It isn’t necessary. Do it only if you want to.

How do you attach the long drapery panels to the pole? You show them in 9266 and 9267.
Drapery instructions are not included in the package. Any draperies or side panels used behind the valance will need to be installed separately on their own rod.

Will it look OK to make this valance without fringe?
Yes, but it is a good idea to put a small cord in the bottom seam to keep the lining from showing at the bottom egde.